[. . . ] Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door reveal (channel) is 1/4"-thick. [. . . ] Start in the middle and pull outward, moving toward the edge (see Figure 2). Figure 3 IMPORTANT Raised panels will reduce the door's 90° swing/zero clearance if the unit is installed next to a wall or similar type of structure. Custom 1/4" Dimensions for 1175 Black & White units: Width: Height: 22-15/16" 26-15/16" IMPORTANT Use care not to damage magnet , located on door bottom when installing door insert. Holding door gasket out of the way, replace handle on door, making sure it is seated properly on insert and that screw holes line up. Carefully examine the door's gasket to assure that it is firmly in contact with the cabinet. Note: When inspecting door alignment, make sure the magnet is aligned with the switch behind the grille. Also make sure the door gasket is not pinched on the hinge side of the door. If the door is not properly aligned, use the following procedure. Adjusting Door Alignment 1. [. . . ] Make sure gasket is firmly in contact with cabinet all the way around the door (no gaps). [. . . ]